1. Install the reagent bottle and keep the balance. If it is a dual function mode, please set the oscillation mode.
2. Turn on the power and set the time according to the surface scale of the machine. If you need to work for a long time, please adjust the timer to the normally open position.
3. Turn on the power switch and set the constant temperature. When the heating reaches the temperature you need, the heating will automatically stop and the green indicator light will light up. When the temperature in the test chamber is lower than the temperature you set, new heat will start again.
4. Turn on the oscillation device: turn on the oscillation switch on the control panel and adjust the oscillation speed knob to the desired oscillation frequency.
5. After finishing the work, turn off the power and set the speed control knob and temperature control knob to the low point of the maximum Z value.
6. Clean the machine and keep it clean.